Adjust the Cutting Position

If there are issues with the alignment of the cutting line and the printed image, use the Calibration function to adjust the cutting position.

Preparation:

  • Use the same printer used for the [Sticker Maker] or [Design Editor] tool.
  • For details on setting up the printer to be used with the mobile device, refer to the printer’s manual.
  • We recommend using the same material as to be used with the alignment cutting function.
  • Make sure that your mobile device and the machine are paired.

Follow the steps below to calibrate the machine sensors.

  1. In the upper-right corner of the Artspira Home screen, tap .

  2. Tap the name of the machine you want to adjust.

    The setting screen appears.

  3. Tap [Calibration].

  4. Select the size of the material to be used, and then tap [Next].

    To calibrate using material attached to a cutting mat, switch on [Mat].

  5. When the print preview screen appears, tap [Print].

    The mobile device’s print options appear. Select the option you want, and then print.

  6. When the first calibration data transfer screen appears, make sure the machine you are using is selected, and then tap [Transfer].

    Follow the in-app instructions to load and cut the material printed in step 5.

    • Load the material so that it feeds in the direction of the ▲ on your printout.
    • Do not eject the material or mat, even after cutting is finished.

  7. When cutting is finished, DO NOT eject the material or mat. Check the cut line and on your mobile device, enter the number corresponding with which printed line aligns with the cutting line in the Artspira screen. When finished, tap [Next].

    The calibration number you enter is sent to the machine.

  8. The second calibration data transfer screen appears. Press (Start/Stop Button) to cut the second data.

  9. Press (Feed Button) and confirm all the cut line on the “+” marks are aligned with the printed image and tap [Done]. If any of the cut lines are misaligned, tap [Start Over] and repeat from step 4.

    If the cutting position remains misaligned, even after repeating the calibration procedure, refer to the following link to check other issues.

    Positioning Issues

Print