Search

Site Map

Change the Remote Codes

Related Models:MFC‑T810W / MFC‑T910DW

The preset Remote Activation Code is *51. The preset Remote Deactivation Code is #51. If you are always disconnected when accessing your External TAD remotely, try changing the three-digit remote codes using the numbers 0-9, *, #.

MFC-T810W

  1. Press Menu.
  2. Press image or image to select the following:
    1. Select [Fax]. Press OK.
    2. Select [Setup Receive]. Press OK.
    3. Select [Remote Codes]. Press OK.
    4. Select [On]. Press OK.
  3. To change the Remote Activation Code, enter the new code. Press OK.
  4. To change the Remote Deactivation Code, enter the new code. Press OK.
  5. Press Stop/Exit.

MFC-T910DW

  1. Press Settings.
  2. Press image or image to select the following:
    1. Select [Fax]. Press OK.
    2. Select [Setup Receive]. Press OK.
    3. Select [Remote Codes]. Press OK.
    4. Select [Remote Codes] again. Press OK.
    5. Select [On]. Press OK.
  3. Do one of the following:
    • To change the Remote Activation Code, press image or image to select [Act.Code] and then press OK. Enter the new code. Press OK.
    • To change the Remote Deactivation Code, press image or image to select [Deact.Code] and then press OK. Enter the new code. Press OK.
  4. Press Stop/Exit.
Related Information
Was this page helpful?

Yes

No

find moreaccept