Search

Site Map

Home > Paper Handling > Load Paper > Load Paper in the Multi-purpose Tray (MP Tray)

Load Paper in the Multi-purpose Tray (MP Tray)

Related Models:MFC‑T910DW
Use the MP Tray for special print media, such as photo paper or envelopes.
  • If the [Check Paper] setting is set to [On] and you set the paper in MP tray, a message appears on the LCD asking if you want to change the paper type and paper size. Change the Paper Size and Paper Type settings if needed, following the LCD instructions.
  • Load only one size and type of paper in the paper tray at a time.
  • When you load a different paper size in the tray, you must change the Paper Size setting in the machine or the paper size setting on your computer.

    Doing this enables the machine to automatically feed paper from the appropriate tray if Auto Tray Select has been set in the machine or printer driver.

  1. Open the MP tray using both hands.
    image
  2. Lift up the paper support.
    image
  3. Gently press and slide the MP tray paper guides to match the width of the paper you are using.
    image
  4. Fan the stack of paper well to avoid paper jams and misfeeds.
    image
    image
    • Always make sure the paper is not curled or wrinkled.
    • You can load only one sheet of Legal/Mexico Legal/India Legal/Folio size paper into the MP tray at a time.
  5. Gently load the paper in the MP tray with the printing surface face up.
    image
    image
    image

    When using envelopes, load the envelopes with the printing surface face up and the flap on the left as shown in the illustration.

    See Related Information: About Envelopes.

    image

    If you are having difficulty loading paper in the MP tray, push the release lever (1) toward the back of the machine, and then load the paper.

    image
  6. Using both hands, gently adjust the MP tray paper guides to fit the paper.
    image
    image
    • DO NOT press the paper guides too tightly against the paper. Doing this may cause the paper to fold and jam.
    • Place the paper in the center of the MP tray between the paper guides. If the paper is not centered, pull it out and insert it again at the center position.
  7. Pull out the paper support (1) until it locks into place, and then unfold the paper support flap (2).
    image
  8. Change the paper size and paper type settings in the [MP Tray Settings] menu, if needed.
    image

    Make sure printing has finished before you close the MP tray.

Related Information
Was this page helpful?

Yes

No

find moreaccept