Search

Site Map

Home > Network > Additional Methods of Configuring Your Brother Machine for a Wireless Network > Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)

Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)

Related Models:DCP‑T510W / DCP‑T710W / MFC‑T810W / MFC‑T910DW

If your wireless access point/router supports WPS (Push Button Configuration), you can use WPS from your machine's control panel menu to configure your wireless network settings.

image
Routers or access points that support WPS are marked with this symbol:
image

DCP-T510W/DCP-T710W/MFC-T810W

  1. Press Menú (Menu).
  2. Press image or image to select the following:
    1. Select [Network]. Press OK.
    2. Select [WLAN]. Press OK.
    3. Select [WPS]. Press OK.
  3. When [WLAN Enable?] appears, press image to select [Yes].
    This will start the wireless setup wizard. To cancel, press Detener/Salir (Stop/Exit).
  4. When the LCD instructs you to start WPS, press the WPS button on your wireless access point/router. Then press OK on your machine. Your machine automatically tries to connect to your wireless network.
If your wireless device is connected successfully, the machine's LCD displays [Connected].

You have completed the wireless network setup. To install the Full Driver & Software Package necessary for operating your machine, insert the Brother installation disc into your computer, or go to your model's Downloads page on the Brother Solutions Center at support.brother.com.

MFC-T910DW

  1. Press Ajustes (Settings).
  2. Press image or image to select the following:
    1. Select [Network]. Press OK.
    2. Select [WLAN]. Press OK.
    3. Select [WPS]. Press OK.
  3. When [Enable WLAN?] appears, press image.
    The wireless setup wizard starts. To cancel, press image.
  4. When the LCD instructs you to start WPS, press the WPS button on your wireless access point/router. Then press image on your machine. Your machine automatically tries to connect to your wireless network.
If your wireless device is connected successfully, the machine's LCD displays [Connected].

You have completed the wireless network setup. To install the Full Driver & Software Package necessary for operating your machine, insert the Brother installation disc into your computer, or go to your model's Downloads page on the Brother Solutions Center at support.brother.com.

Related Information
Was this page helpful?

Yes

No

find moreaccept