Search

Home > Fax > Receive a Fax > Remote Fax Retrieval > Remote Retrieval Commands

Remote Retrieval Commands

Related Models:MFC‑L2710DW / MFC‑L2713DW / MFC‑L2715DW / MFC‑L2716DW / MFC‑L2730DW / MFC‑L2750DW / MFC‑L2751DW / MFC‑L2770DW / MFC‑L2771DW
Use the Remote Commands in this table to access fax commands and options when you are away from your Brother machine. When you call the machine and enter your remote access code (three digits followed by *), the system will sound two short beeps and you must enter a Remote Command (column 1), followed by one of the options (column 2) for that command.
Remote commands Options Operation details
95 Change the Fax Forwarding, or Fax Storage settings
1 OFF

You can select Off after you retrieve or erase all your messages.

2 Fax Forwarding

One long beep means the change is accepted. If you hear three short beeps, you cannot make a change because something has not been set up (for example, a Fax Forwarding number has not been registered). You can register your Fax Forwarding number by entering 4. After you register the number, Fax Forwarding will work.

4 Fax Forwarding number
6 Fax Storage
96 Retrieve a fax
2 Retrieve all faxes

Enter the fax number of a remote fax machine to receive stored fax messages.

3 Erase faxes from memory

If you hear one long beep, fax messages have been erased from memory.

97 Check the receiving status
1 Fax

Check whether your machine has received any faxes. If yes, you will hear one long beep. If not, you will hear three short beeps.

98 Change the Receive Mode
1 External TAD One long beep means the change has been accepted.
2 Fax/Tel
3 Fax Only
90 Exit

Press 9 0 to stop remote retrieval. Wait for the long beep, then hang up.

Was this page helpful?

Yes

No