Search

Home > Paper Handling > Load Paper > Load Paper in the Paper Tray > Load Photo Paper in the Paper Tray

Load Photo Paper in the Paper Tray

  • If the [Check Paper] setting is set to [On] and you pull the paper tray out of the machine, a message appears on the LCD asking if you want to change the paper type and paper size. Change the Paper Size and Paper Type settings if needed, following the LCD instructions.
  • Load only one size and type of paper in the paper tray at a time.
  • When you load a different paper size in the tray, you must change the Paper Size setting in the machine or the paper size setting on your computer.
  1. If the paper support flap (1) is open, close it, and then close the paper support (2).
    image
  2. Pull the paper tray completely out of the machine.
    image
  3. Open the output paper tray cover (1).
    image
  4. Gently press and slide the paper width guides (1) to fit the paper size, and then lift up the stopper (2).
    image
  5. Close the output paper tray cover.
    image
  6. Load up to 20 sheets of photo paper with the printing surface face down.
    Loading more than 20 sheets of photo paper may cause paper jams.
    image
  7. Gently adjust the paper width guides (1) to fit the paper.
    Make sure the paper width guides touch the edges of the paper and the paper is flat in the tray.
    image
  8. Slowly push the paper tray completely into the machine.
    image
  9. Pull out the paper support (1) until it locks into place, and then unfold the paper support flap (2).
    image
Was this page helpful?

Yes

No