Search

Site Map

Change the Remote Codes

Related Models:MFC‑J491DW / MFC‑J497DW / MFC‑J890DW / MFC‑J895DW

The preset Remote Activation Code is *51. The preset Remote Deactivation Code is #51. If you are always disconnected when accessing your External TAD remotely, try changing the three-digit remote codes using the numbers 0-9, *, #.

MFC-J491DW/MFC-J497DW

  1. Press Settings.
  2. Press image or image to select the following:
    1. Select [Fax]. Press OK.
    2. Select [Setup Receive]. Press OK.
    3. Select [Remote Codes]. Press OK.
    4. Select [Remote Codes] again. Press OK.
    5. Select [On]. Press OK.
  3. Do one of the following:
    • To change the Remote Activation Code, press image or image to select [Act.Code] and then press OK. Enter the new code. Press OK.
    • To change the Remote Deactivation Code, press image or image to select [Deact.Code] and then press OK. Enter the new code. Press OK.
  4. Press Stop/Exit.

MFC-J890DW/MFC-J895DW

  1. Press image [Settings]>[All Settings]>[Fax]>[Setup Receive]>[Remote Codes].
  2. Do one of the following:
    • To change the Remote Activation Code, press [Act.Code]. Enter the new code, and then press [OK].
    • To change the Remote Deactivation Code, press [Deact.Code]. Enter the new code, and then press [OK].
    • If you do not want to change the Codes, go to the next step.
    • To turn the Remote Codes [Off] (or [On]), press [Remote Codes]. Press [Off] (or [On]).
  3. Press image.
Related Information
Was this page helpful?

Yes

No

find moreaccept