![]() ![]() | ![]() ![]() |
1 | Press Menu. Press ![]() ![]() Press ![]() ![]() Choose WLAN. | |||||||||||||||||||||||||
2 | Turn on your computer. Close any applications running before you start configuration. | |||||||||||||||||||||||||
3 | Put the supplied CD-ROM into your CD-ROM drive. The opening screen will appear automatically. If the model name screen appears, choose your machine. If the language screen appears, choose your language. | |||||||||||||||||||||||||
4 | The CD-ROM main menu will appear. Click Advanced. ![]() | |||||||||||||||||||||||||
5 | Click Wireless LAN Setup Wizard. ![]() | |||||||||||||||||||||||||
6 | Choose Automatic install (Advanced) and click Next. ![]() | |||||||||||||||||||||||||
7 | Read the Important Notice. Check the box after you confirm the wireless setting is enabled, and then click Next. ![]() | |||||||||||||||||||||||||
8 | Confirm the on-screen message and click Next. ![]() | |||||||||||||||||||||||||
9 | Press Menu, ![]() ![]() ![]() ![]() ![]() ![]()
| |||||||||||||||||||||||||
10 | The machine searches for an access point that supports SecureEasySetup™, Wi-Fi Protected Setup™ or AOSS™ for 2 minutes. | |||||||||||||||||||||||||
11 | Put your access point in the SecureEasySetup™ mode, Wi-Fi Protected Setup™ mode or AOSS™ mode, depending on what is supported by your access point. Please refer to the instruction manual that came with your access point. | |||||||||||||||||||||||||
12 | If the LCD shows Connected, the machine has successfully connected to your router or access point. You can now use your machine in a wireless network. If the LCD shows Connection Error, a session overlap has been detected. The machine has detected more than one access point/router on your network with the SecureEasySetup™ mode, the Wi-Fi Protected Setup™ mode or AOSS™ mode enabled. Make sure that only one access point/router has the SecureEasySetup™ mode, the Wi-Fi Protected Setup™ mode or the AOSS™ mode enabled and try starting from 9 again. If the LCD shows No Access Point, the machine has not detected your access point/router on your network with the SecureEasySetup™ mode, the Wi-Fi Protected Setup™ mode or AOSS™ mode enabled. Move the machine closer to your access point/router and try starting from 9 again. If the LCD shows Connection Fail, the machine has not successfully connected to your access point/router. Try starting from 9 again. If the same message is indicated again, reset the machine back to the default factory settings and try again. (For resetting, see Restoring the network settings to factory default.) LCD messages when using the SES/WPS/AOSS control panel menu
| |||||||||||||||||||||||||
13 | Click Next. ![]() | |||||||||||||||||||||||||
14 | Check the box after you confirm that you have completed the wireless settings, and then click Finish. ![]() |
![]() |
![]() ![]() | ![]() ![]() |