1 | Press Menu. |
2 | Press or to choose Network. Press OK. |
3 | For DCP-373CW, DCP-375CW, DCP-377CW, DCP-593CW, DCP-595CW, DCP-597CW and MFC-495CW Press or to choose WLAN. Press OK. |
4 | Press or to choose WPS w/PIN Code. Press OK. |
5 |
(For DCP-373CW, DCP-375CW, DCP-377CW, MFC-253CW, MFC-255CW and MFC-257CW)
When Change to WLAN? or WLAN Enable? is displayed, press or 1 to accept. This will start the wireless setup wizard. To cancel, press Stop/Exit.
(For DCP-593CW, DCP-595CW, DCP-597CW and MFC-495CW)
When Network I/F switched to Wireless is displayed, press OK to accept. This will start the wireless setup wizard. To cancel, press Clear/Back. |
6 | The LCD will show an 8 digit PIN and the machine starts searching for an access point for 5 minutes. |
7 | Using a computer that is on the network, type “http://access point’s IP address/” into your browser. (Where “access point’s IP address” is the IP address of the device that is used as the Registrar1.) Go to the WPS (Wi-Fi Protected Setup™) setting page and input the PIN which the LCD shows in 6 to the Registrar and follow the on-screen instructions. If you are using your Windows Vista® computer as a Registrar, perform following instructions. |
8 | If the LCD shows Connected, the machine has successfully connected to your router or access point. You can now use your machine in a wireless network. If the LCD shows No Access Point or Connection Fail, the machine has not successfully connected to your router or access point. Try starting from 4 again. If the same message is indicated again, reset the machine back to the default factory settings and try again. For resetting, see Restoring the network settings to factory default. |
1 | Press MENU. |
2 | Press Network. |
3 | Press WLAN. |
4 | Press WPS w/PIN Code. |
5 | When Switch Network interface to wireless? is displayed, press Yes to accept. This will start the wireless setup wizard. To cancel, press Stop/Exit. |
6 | The LCD will show an 8 digit PIN and the machine starts searching for an access point for 5 minutes. |
7 | Using a computer that is on the network, type “http://access point’s IP address/” into your browser. (Where “access point’s IP address” is the IP address of the device that is used as the Registrar1.) Go to the WPS (Wi-Fi Protected Setup) setting page and input the PIN which the LCD shows in 6 to the Registrar and follow the on-screen instructions. If you are using your Windows Vista® computer as a Registrar, follow the next instructions. |
8 | If the LCD shows Connected, the machine has successfully connected to your router or access point. You can now use your machine in a wireless network. If the LCD shows No Access Point or Connection Fail, the machine has not successfully connected to your router or access point. Try starting from 4 again. If the same message is indicated again, reset the machine back to the default factory settings and try again. For resetting, see Restoring the network settings to factory default. |
|