Home > Routine Maintenance > Replace the Battery
Replace the Battery
- To ensure the highest performance and longest life from the rechargeable battery, when storing the Label Printer for a long period of time:
- Charge once every six months.
- Store in a cool dry place out of direct sunlight in environments between 10°C and 35°C.
- Dispose of the battery at an appropriate collection point, not in the general waste stream. Be sure to observe all applicable federal, state, and local regulations.
- DANGER
- Do not dispose of the battery with household waste. There is a risk of environmental damage, explosion, or fire.
- IMPORTANT
- When removing and replacing the rechargeable battery, cover the terminals of the old rechargeable battery with tape to avoid creating a short in the battery.
PT-E720BT
PT-E920BT
PT-E720BT
- Turn the Label Printer off.
- Place your fingers near the Tape Exit Slot.
- Open the Cassette Cover.
- Remove the two screws from the Battery Cover using a flat-bladed screwdriver and remove the Battery Cover.
- Remove the battery.
- Insert the new battery.
- Reattach the Battery Cover, reinsert the screws, and tighten them with a flat-bladed screwdriver.
- Close the Cassette Cover.
PT-E920BT
- Turn the Label Printer off.
- Place your fingers near the Tape Exit Slot.
- Open the Cassette Cover.
- Remove the Battery Cover.
- Remove the battery.
- Insert the new battery.
- Reattach the Battery Cover.
- Close the Cassette Cover.
Did you find the information you needed?