Search

Site Map

Home > Appendix > Optional Accessories > Single Active Docking Station (Optional: PA-CR-005) > Charge the Battery Using the Single Active Docking Station

Charge the Battery Using the Single Active Docking Station

The Single Active Docking Station (PA-CR-005) cannot recharge the printer's battery without being connected to an AC power outlet using the AC Adapter (PA-AD-600A).

Charge the Battery

  1. Connect the AC Adapter to the Docking Station's DC Connector.
    image
  2. Connect the AC power cord to the AC Adapter.
  3. Connect the AC power cord to a nearby AC power outlet.
  4. Align the Docking Station Terminals of the Docking Station and the printer.
    image
  5. Press the printer down and onto the Docking Station until the latches lock it firmly in place.
    The printer’s LED Indicator lights in orange when charging.
  • The printer’s LED Indicator will turn off when charging is complete.

Remove the Printer from the Docking Station

  • Push the Eject Button on the back of the Docking Station, lift the printer, and then remove it from the Docking Station.
    image
    1. Eject Button

Lock the Eject Button

  • Insert a cotter pin (or similar) through the hole as illustrated below.
    image
    Use a Low Carbon Steel Extended Prong Retaining Cotter Pin (not included): Length: 1.97" (50 mm), Pin Diameter: 0.08" (2 mm)
    image
    image
    1. Diameter: 0.09" (2.3 mm)
    2. Length: 1.62" (41.2 mm)
    image
    To purchase the Cotter Pin, contact your local Brother dealer.
Related Information
Did you find the information you needed?

find moreaccept