Home > Set Up Your Printer > Load Media Roll > Load a Large Diameter Roll
Load a Large Diameter Roll
- Press and hold
to turn the printer off.
- Open the Rear Feed Port Cover.
- Pull up the release levers on both sides of the printer to unlock the Roll Compartment Cover.
- Hold the front of the printer, and firmly lift the Roll Compartment Cover to open it.
- CAUTION
- Do not touch the Tear Bar with your hands. Doing so may result in injury.
- Rotate the Adjuster Dial to lock the Roll Guides in the appropriate position.
- Insert the first label, printing surface facing up, through the Rear Feed Port. *1
- NOTE
-
- Position the printer and the external roll holder so that the top of the printer's Rear Feed Port is higher than the media roll's pull-out position.
- Place the roll with the printing surface facing up.
- Do not allow external roll to touch any cables attached to the printer.
- Depending on the roll size and installation method, the roll may become overloaded and cannot feed labels/media. If this happens, reduce the printing speed.
- Make sure the labels pass under the Media Roll Holder, as shown in the illustration.
- Feed the end of the backing paper under the Media Guide Tips (1).Make sure the label extends slightly out of the Label Exit Slot.
- Close the Roll Compartment Cover until it locks into place.
- CAUTION
- Be careful when closing the Roll Compartment Cover. There is a risk of injury if your finger gets pinched between the upper and lower parts of the cover.
- IMPORTANT
-
- Do not leave any printed labels in the printer. Doing so will cause label jams.
- When the printer is not in use, remove any media from it and close the Roll Compartment Cover.
*1
When printing die-cut labels, make sure that the label pull-out position is lower than the Rear Feed Port. If fed from above, the front edge of a die-cut label could catch on the upper part of the Rear Feed Port, peel from its backing, and jam the printer.
We recommend checking the roll each time you print die-cut labels to confirm the correct label pull-out position and the Rear Feed Port height, as shown in the illustration.
Did you find the information you needed?