SDX1200
FAQs & Troubleshooting |
SDX1200
Sort by
13 Results
1. 06/06/2024
The Material to be Cut is Not Cleanly Cut with the Roll Feeder.
2. 03/02/2020
How to Activate an Accessory Kit* (Rhinestone, Emboss Kit, etc.) for the Cutting Machine.
3. 11/03/2019
Retrieving Roll Feeder Data On the Machine and Cutting
4. 11/03/2019
How should I make a pattern to be cut with the roll feeder?
5. 11/03/2019
Cutting data is not displayed in Roll Feeder.
6. 21/12/2018
How Do I Perform Trial Cutting for Roll Feeder? (Test Cut)
7. 21/12/2018
What Should I Do If the Trimmer Blade Has Been Removed from the Trimmer?
8. 21/12/2018
What Should I Do If the Material is not being Cleanly Cut by the Trimmer Blade?
9. 17/12/2018
How to Install the Roll Feeder
10. 14/12/2018
Care and Maintenance (Cleaning the Trimmer Blade)
11. 14/12/2018
Using the trimmer blade to trim the end of the material
12. 14/12/2018
The rolled material did not feed correctly.
13. 03/10/2018
Adjusting the Position of the Feed Roller