CM600
FAQ & Fehlerbehebung |
9 Ergebnisse
Sortierfolge
- 110.07.2017Not all of the material to be cut is cut. Some areas remain uncut.
- 210.07.2017The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
- 310.07.2017The mat is fed in at an angle and is not fed during cutting / drawing.
- 410.07.2017The mat or the material catches on a feed roller during cutting/drawing.
- 509.06.2017I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good.
- 616.01.2017What should I do if the entire pattern is not cut?
- 716.01.2017What should I do if part of the material is not cut?
- 808.08.2016What should I do if the scanned and cut positions are misaligned?
- 919.08.2015There are deep cuts completely through the mat.