1. 10.07.2017

Not all of the material to be cut is cut. Some areas remain uncut.

2. 10.07.2017

The material to be cut/drawn or original to be scanned peels off during cutting/scanning.

3. 10.07.2017

The mat is fed in at an angle and is not fed during cutting / drawing.

4. 10.07.2017

The mat or the material catches on a feed roller during cutting/drawing.

5. 09.06.2017

I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good.

6. 16.01.2017

What should I do if the entire pattern is not cut?

7. 16.01.2017

What should I do if part of the material is not cut?

8. 08.08.2016

What should I do if the scanned and cut positions are misaligned?

9. 19.08.2015

There are deep cuts completely through the mat.