TJ-4422TN
 |
Preguntas frecuentes y solución de problemas |
How to reset the printer settings by directly operating the printer
Printer initialization clears the printer's DRAM and restores its factory settings.
-
Turn off the printer.
-
Press and hold the right Selection button, and then turn on the Power Switch.
-
Release the button when Factory Default appears on the screen.
You can also release the button when the LED is flashing in green (5 times).
The LED color will change in the following order:
Amber > red (5 times) > amber (5 times) > green (5 times) > green/amber (5 times) > red/amber (5 times) > green (lit)
After the initialization, the following factory settings will be restored:
| Parameter |
Default setting |
| Speed |
152.4 mm/sec (6 ips) (203 DPI)
101.4 mm/sec (4 ips) (300 DPI)
76.2 mm/sec (3 ips) (600 DPI) |
| Density |
8 |
| Label Width |
101.5 mm (4") |
| Label Height |
101.5 mm (4") |
| Sensor Type |
Gap sensor |
| Gap Setting |
3 mm (0.12") |
| Print Direction |
0 |
| Reference Point |
0,0 (upper left corner) |
| Offset |
0 |
| Tear Mode |
On |
| Peeler Mode |
Off |
| Cutter Mode |
Off |
| Rewinder Mode |
Off |
| Code Page |
850 |
| Country Code |
001 |
| Clear Flash Memory |
No |
Si no obtuvo una respuesta, ¿ha revisado otras preguntas frecuentes?
¿Ha revisado los manuales?
Si necesita asistencia, contáctese con el servicio al cliente de Brother:
Comentarios sobre el contenido
Para ayudarnos a mejorar el soporte, bríndenos sus comentarios a continuación.
