PT-D600
 |
คำถามที่พบบ่อย และการแก้ปัญหาเบื้องต้น |
My label is not cut automatically after printed.
Check if "Cut Option" is set to "Chain", "No Cut", or "Special Tape". The tape is not cut after each label is printed or only cut after the last label is printed depending on the tape cutting option setting.
Please refer to the following methods of cutting after each label is printed, and cutting after the last label is printed.
Method 1. Automatically cut after each label is printed.
Method 2. Cut after the last label is printed.
Method 1. The tape can be cut automatically after each label is printed by changing the "Cut Option" setting.
If you are using Fabric Iron-on Tapes or Extra Strength Adhesive tapes, select the "Special Tape" setting to protect the cutter blade. After printing, remove the tape cassette from the printer and use scissors to cut the tape.
-
Press the [Function] key (
) to display the Edit menu.
-
Select "Cut Option" using
or 
key, and then press the [OK] key ( 
) or [Enter] key ( 
/ 
).
-
Select "Large Margin" or "Small Margin" using or key, and then press the [OK] key ( ) or [Enter] key ( / ).
Method 2. Cut the last label which is not fed and cut automatically.
If you printed on Fabric Iron-on Tapes or Extra Strength Adhesive tapes, feed the tape to create an enough margin, then remove the tape cassette from the printer and cut the tape using scissors. Please refer to the steps below.
-
After the last label is printed, hold down the [Shift] key (
/ 
) and press the [Preview] key ( 
) to display the "Feed & Cut" menu.
-
Using or key, select "Feed & Cut" if you have the printer cut the label, or select "Feed Only" if you cut the tape manually.
Press the [OK] key ( ) or [Enter] key ( / ).
