PT-E310BT
 |
FAQ & Fehlerbehebung |
How do I make a label with a barcode?
Set Bar Code Parameters and Enter the Bar Code Data
-
Press the Shift key (
/ 
), and then press the Cable Wrap/Barcode key ( 
/ 
).
The Bar Code Setup screen is displayed.
* Up to five bar codes can be entered on a label. -
Press
or 
to select an attribute, and then press 
or 
to set a value for that attribute.Characters may not appear below the bar code even when "On" is selected for "Under #", depending on the tape width being used, the number of lines entered, or the current character style settings.
-
Press the OK key to apply the settings.
* New settings are NOT applied if you do not press the OK key. -
Type in the bar code data.
Special characters can be entered in the bar code when using the CODE39, CODE128, CODABAR, GS1-128, QR Code or Data Matrix protocols. When not using special characters, go to step 7.
-
Press the Shift key ( / ), and then press the Faceplate/Symbol key (
/ 
).
A list of characters available for the current protocol is displayed. -
Press or to select a character, and then press the OK key to insert the character in the bar code data.
-
Press the OK key to insert the bar code in the label.
The bar code is displayed on the text entry screen.
Bar Code Settings
| Attribute | Value |
|---|---|
| Protocol | CODE39, CODE128, EAN-8, EAN-13, GS1-128 (UCC/EAN-128), UPC-A, UPC-E, I-2/5 (ITF), CODABAR |
| Width |
Small, Large |
| Under# (characters printed below bar code) |
On, Off |
| C.Digit (check digit) |
Off, On (only available for the CODE39, I-2/5 and CODABAR protocols) |
Rückmeldung zum Inhalt
Helfen Sie uns dabei, unseren Support zu verbessern und geben Sie uns unten Ihre Rückmeldung.
