The control panel button has the following functions:
•
Wake-up
If the printer is in Sleep mode, press the Go button to wake the printer up and go to the Ready state.
•
Error recovery
If there is an error, the printer will recover automatically from some errors. If an error is not automatically cleared, press the Go button to clear the error, and then continue to use the printer.
•
Form feed
If the green Ready LED blinks for a long time, press the Go button. The printer will print any data that is left in the printer memory.
•
Cancel printing
While printing press the Go button for about 4 seconds until all the LEDs light up. The Ready and Error LEDs will flash as the job is being cancelled.
•
Reprint
To reprint the last document, press the Go button for about 4 seconds until all the LEDs light up.
Print a test page
You can use the Go button or the printer driver to print a test page.
Using control panel button
1
Turn off the printer.
2
Make sure that the front cover is closed and the power cord is plugged in.
3
Hold down the Go button as you turn on the power switch. Keep the Go button pressed down until the Toner, Drum and Error LEDs light up. Release the Go button. Make sure that the Toner, Drum and Error LEDs are off.
4
Press the Go button again. The printer will print a test page.
