1 | Turn on your Macintosh®. | ||||
2 | Put the supplied CD-ROM into your CD-ROM drive. Double-click the HL4040_4050_4070 icon on your desktop. Double-click the Start Here icon. Select your printer and the language. | ||||
3 | Click Install Printer Driver. | ||||
4 | Click Wireless Network users. | ||||
5 | Choose Wireless Setup and Driver Install or Wireless Setup Only, and then click Next. | ||||
6 | Read the Important Notice and check the box after you confirm this setting, and then click Next. | ||||
7 | Choose Manual and then click Next. | ||||
8 | For configuration, it is recommended that you temporarily connect your Brother wireless device (your printer) directly to a free port on your access point, hub or router using a network cable.
| ||||
9 | Connect the Brother wireless device to your access point using a network cable and click Next. Go to 14. | ||||
10 | If you choose This computer has wireless capability., check I am using an access point in infrastructure mode, and then click Next. Go to 12. If you are using a wired computer, choose This computer uses a network cable to connect to the wireless network., you must configure the wireless settings from the control panel. Click Finish and see Using the Setup Wizard from the control panel. If you have already completed the wireless settings and chose to install the printer driver in step 5, click Next. Go to 11. | ||||
11 | Check the box after you confirm that you have completed the wireless settings, and then click Next. | ||||
12 | You need to temporarily change your computer’s wireless settings. Follow the on-screen instructions. Make sure you take notes on all the settings such as SSID or channel of your computer. You will need them to return your computer back to its original wireless settings, and then click Next. | ||||
13 | To communicate with the un-configured wireless printer, temporarily change the wireless settings on your computer to match printer’s default settings shown on this screen. Check the box after you confirm these settings, and then click Next. | ||||
14 | Choose the printer you wish to configure, and click Next. If the list is blank, check if the access point and the printer are powered on, and then click Refresh. | ||||
15 | The wizard will search for wireless networks available from your printer. Choose the access point you wish to associate the printer with, and then click Next. | ||||
16 | If your network is not configured for Authentication and Encryption, the following screen will appear. To continue configuration, click OK and go to 18. | ||||
17 | If your network is configured for Authentication and Encryption, the following screen will appear. When configuring your Brother wireless printer, you must ensure that it is configured to match the Authentication and Encryption settings of your existing wireless network. Choose the Authentication Method and Encryption Mode from the pull-downs in each setting box. Then enter the Network key and click Next. | ||||
18 | Click Next. The settings will be sent to your printer. The settings will remain unchanged if you click Cancel. | ||||
19 | Follow the on-screen instructions.
|
|