Home PrintPrevious Next

Configuration in Ad-hoc mode

Note Note
• 
If you are going to connect the printer to your network, we recommend that you contact your system administrator prior to installation.
• 
Before installation, if you are using Personal Firewall software (e.g. Windows Firewall), disable it. Once you are sure that you can print, restart your Personal Firewall software.

Before configuring the wireless settings

 IMPORTANT
 
If you have previously configured the wireless settings of the printer, you must reset the print server back to the default factory settings (see Restoring the network settings to factory default) and enable the WLAN setting from the control panel. See Enabling the wireless network using the control panel on this page.
Enabling the wireless network using the control panel
1
Make sure that the power cord is plugged in.
2
Turn on your printer and wait until the printer is in the Ready state.
3
Press any of the Menu buttons (+, -, OK or Back) to take the printer off-line.
Ready
 
next
Select Bsymbol.utriBsymbol.dtri or OK
Machine Info.
4
Press the + or - button to select LAN.
Select Bsymbol.utriBsymbol.dtri or OK
LAN
5
Press OK to move to the next menu level.
LAN
Wired
6
Press the + or - button to select WLAN.
LAN
WLAN
7
Press OK to move to the next level.
WLAN
TCP/IP
8
Press the + or - button to select WLAN Enable.
WLAN
WLAN Enable
9
Press OK to move to the next level.
WLAN Enable
Off
10
Press the + or - button to select On.
WLAN Enable
On
11
Press OK.
Accepted appears on the second line of the LCD.
WLAN Enable
Accepted
OK!
 
The WLAN setting is enable.
Page Top
Home PrintPrevious Next