Scan to Image

When you choose Scan to Image, your document will be scanned and sent directly to the Macintosh^® you designated on your network. ControlCenter2 will activate the default graphics application on the designated Macintosh^®. You can change the Scan configuration. (See Image (example: Apple^® PreView).)

Put the document face up in the ADF, or face down on the scanner glass.

Press

(Scan).

Press

to choose Scan to Image.

Press OK.

If your machine is an MFC-9440CN or DCP-9040CN, go to Step 5.

If your machine is an MFC-9840CDW, go to Step 4.

Press

to choose 1sided, 2sided (L)edge or 2sided (S)edge. Press OK.

Note

If you want to scan a document using the duplex scanning feature, you need to put the document in the ADF and then choose 2sided (L)edge or 2sided (S)edge depending on your document layout.

Press

to choose the destination Macintosh^® you want to send to.

Press OK.

If the LCD prompts you to enter a Pin number, enter the 4-digit Pin number for the destination Macintosh^® on the control panel.

Press OK.

Press Mono Start or Color Start.

The machine starts the scanning process.

Note

•	Scan type depends on the settings on the Device Button tab, Mono Start or Color Start do not change the settings.
•	If you want the scanned data in color, choose color in the scan type on the Device Button tab of the ControlCenter2 configuration. If you want the scanned data in black and white, choose black and white in the scan type on the Device Button tab of the ControlCenter2 configuration. (See Image (example: Apple^® PreView).)

Page Top