Enhance Photos

You can edit and add effects to your photos and view them on the LCD before printing.

Note

The Enhance Photos feature is supported by technology from Reallusion, Inc.

Make sure you have put a memory card or USB Flash memory drive in the correct slot.

Press

(Photo Capture).

Press Enhance Photos.

Note

•	Eight thumbnails are displayed at a time with the current page number and total number of pages listed under the thumbnails.
•	Press or repeatedly to select each photo, or hold down to scroll through all photos.
•	Press to start Slide Show.

Press a photo from the thumbnails.

Press Enhance or Trim. You can also choose both together. Press OK.

Do one of the following:

•	If you chose Enhance, go to step 6.
•	If you chose Trim, go to step 7.

Press the effect you wish to add.

Press OK.

Go to step 8.

Note

•

You have 7 ways to add effects to your photo.

	Auto Correct The machine decides the suitable effect for your photo.
	Enhance Skin Best used for adjusting portrait photographs. It adjusts human skin colour. Press or to adjust the level of contrast.
	Remove Red-Eye The machine will attempt to remove red-eye from your photo. If red-eye detection fails, you can press the Try Again button to re-detect.
	Enhance Scenery Best used for adjusting landscape photographs. It highlights green and blue areas in your photo. Press or to adjust the level of contrast.
	Monochrome You can convert the colour of your photo to monochrome.
	Sepia Adds a sepia tone (shades of brown) effect to your photo.
	Auto Correct & Remove Red-Eye The machine decides the suitable effects for your photo. Also, it will attempt to remove red-eye from your photo.

•

There are some cases when red-eye may not be removed.

•	When the face is too small in the image.
•	When the face is turning too far up, down, left or right.

•

After adding each effect, you can enlarge the view of the image by pressing

. To go back to the original size, press

•

While the image is enlarged, you can move around the image with up (

), down (

), left (

) and right (

•

Press Cancel to return to the list of effects.

Adjust the red frame around your photo.

The part inside of the red frame will be printed.

•	Press + or - to enlarge or reduce the frame size.
•	Press , , or to move the position of the frame.
•	Press to rotate the frame.

Press OK when you have finished adjusting the frame setting.

Press OK to confirm.

Note

If your photo is very small or has irregular proportions you may not be able to trim the photo. The LCD will display Image Too Small. or Image Too Long.

Enter the number of copies you want either by pressing the number box directly and enter the number you want or pressing + or -.

Press OK.

Do one of the following:

•	Press Print Setting and change the print settings. (See PhotoCapture Center™ print settings.)
•	If you do not want to change any settings, press Colour Start to print.

Page Top