Home Print Previous Next

For network users
(For models with built-in network support)

1
Put a CompactFlash®1, Memory Stick®2, Memory Stick Pro™, MultiMediaCard™, SecureDigital™ or xD-Picture Card™3 into your machine.
1
This product also supports CompactFlash® type1.
2
MagicGate Memory Stick® and Memory Stick Pro™ can be used, but any music data that is stored on the stick cannot be read.
3
This product supports xD-Picture Card™ Type M/Type H (Large Capacity).
2
Launch any FTP software or any web browser in which FTP is supported. (e.g. Safari, Internet Explorer)
Your browser software accesses the media card using the FTP protocol and the network Host Name of the machine. In the address bar, enter ftp://XXX.XXX.XXX.XXX (where XXX.XXX.XXX.XXX is the IP address of your Brother machine).
Your browser software appears and a list of file names on your media card is shown.
3
Click the name of the file you want to see.
When you take out a media card, do the following to prevent damage to the media card:
1
Close the browser.
2
Wait until the Graphic (PhotoCapture) key stops blinking before taking out the media card.
CAUTION CAUTION
 
DO NOT unplug the power cord or remove a CompactFlash®, Memory Stick®, Memory Stick Pro™, MultiMediaCard™, SecureDigital™ or xD-Picture Card™ from the machine while it is reading the card (when the Graphic (PhotoCapture) key is flashing). You could lose your data or damage the card.
If you take out the media card while the PhotoCapture key is flashing, you must restart your Macintosh® at once before putting the same media card back into the machine. If you do not restart your Macintosh®, the data on your media card may be destroyed.
Page Top
Home Print Previous Next