![]() ![]() | ![]() ![]() |
1 | Turn on the machine by plugging in the power cord. |
2 | Turn on your computer. |
3 | Put the supplied CD-ROM into your CD-ROM drive. The opening screen will appear automatically. If the model name screen appears, choose your machine. If the language screen appears, choose your language. |
4 | The CD-ROM main menu will appear. Click Initial Installation or Advanced. ![]() ![]() |
5 | Click Wireless LAN Setup Wizard. ![]() ![]() |
6 | Choose Step by Step install (Recommended) and then click Next. ![]() |
7 | Choose With cable (Recommended) and then click Next. ![]() |
8 | Read the Important Notice. Check the box after you confirm the wired setting is enabled, and then click Next. ![]() |
9 | Temporarily connect the Brother wireless device to your access point using a network cable (not included) and click Next. ![]() ![]() |
10 | Choose the machine you wish to configure, and click Next. If the list is blank, check if the access point and the machine are powered on, and then click Refresh. ![]() |
11 | The wizard will search for wireless networks available from your machine. Choose the access point you wish to associate the machine with, and then click Next. ![]() ![]() |
12 | If your network is not configured for Authentication and Encryption, the following screen will appear. To continue configuration, click OK and go to step 14. ![]() |
13 | Then enter the Network Key and Confirm Network Key, and then click Next. ![]() |
14 | Click Next. The settings will be sent to your machine. The Network Configuration page will be printed.The settings will remain unchanged if you click Cancel. ![]() ![]() |
15 | Check the printed Network Configuration page. Choose the status as it is shown for the Wireless Link Status on the Network Configuration page. Click Next. If your status is "Link OK.", go to step 17. If your status is "Failed To Associate", go to step 16. ![]() |
16 | Click Finish. Wireless setup failed as it was unable to associate with a wireless network. This is probably due to incorrect security settings. Reset the print server back to its factory default settings. (See Restoring the network settings to factory default.) Confirm the security settings of your wireless network and try starting from step 5 again. ![]() |
17 | Disconnect the network cable between your access point (hub or router) and the machine, and click Next. ![]() |
18 | Check the box after you confirm that you have completed the wireless settings, and then click Finish. ![]() |
![]() |
If your wireless settings fail, an error message will appear during the installation of MFL-Pro Suite and the installation will be terminated. If you encounter this failure, go to step 5 and setup the wireless connection again. |
![]() ![]() | ![]() ![]() |