1 | Turn on the machine by plugging in the power cord. | |||||||||||||||||||||||
2 | Press Menu. Press or to choose Network, press OK. Press or to choose Network I/F, press OK. Choose WLAN. | |||||||||||||||||||||||
3 | Turn on your Macintosh. | |||||||||||||||||||||||
4 | Put the supplied CD-ROM into your CD-ROM drive. Double-click the MFL-Pro Suite icon on your desktop. | |||||||||||||||||||||||
5 | Double-click the Utilities. | |||||||||||||||||||||||
6 | Double-click the Wireless Device Setup Wizard. | |||||||||||||||||||||||
7 | Choose Automatic install (Advanced) and click Next. | |||||||||||||||||||||||
8 | Read the Important Notice and click Next. | |||||||||||||||||||||||
9 | Confirm the on-screen message and click Next. | |||||||||||||||||||||||
10 | Press Menu, or to choose Network and press OK. Press or to choose WLAN and then press OK. Press or to choose SES/WPS/AOSS and press OK.
| |||||||||||||||||||||||
11 | The machine searches for an access point that supports SecureEasySetup™, Wi-Fi Protected Setup™ or AOSS™ for 2 minutes. | |||||||||||||||||||||||
12 | Put your access point in the SecureEasySetup™ mode, Wi-Fi Protected Setup™ mode or AOSS™ mode, depending on what is supported by your access point. Please refer to the instruction manual that came with your access point. | |||||||||||||||||||||||
13 | If the LCD shows Connected, the machine has successfully connected to your router or access point. You can now use your machine in a wireless network. If the LCD shows Setting WLAN, Connecting WLAN, then Connection Failed, the machine has not successfully connected to your router or access point. Try starting from 10 again. If the same message is indicated again, reset the machine back to the default factory settings and try again. To reset, see Restoring the network settings to factory default. If the LCD shows Setting WLAN, then Connection Failed or Incorrect Mode, a session overlap was detected (see the table below). The machine has detected more than one router or access point on your network that has the Wi-Fi Protected Setup™ mode or AOSS™ mode enabled. Make sure that only one router or access point has the Wi-Fi Protected Setup™ mode or AOSS™ mode enabled and try starting from 10 again. LCD messages when using the SES/WPS/AOSS control panel menu
| |||||||||||||||||||||||
14 | Click Next. | |||||||||||||||||||||||
15 | Check the box after you confirm that you have completed the wireless settings, and then click Finish. |