Home PrintPrevious Next

4 Network Scanning
(For models with built-in network)

To use the machine as a network scanner, the machine must be configured with a TCP/IP address. You can set or change the address settings from the control panel (See Control Panel Setup in the Network User’s Guide) or by using the BRAdmin Professional software. If you installed the machine following the instructions for a network user in the Quick Setup Guide then the machine should already be configured for your network.
Note Note
•
For network scanning, a maximum of 25 clients can be connected to one machine on a network. For example, if 30 clients try to connect at a time, 5 of those clients will not be shown on the LCD.
•
If your PC is protected by a firewall and is unable to network scan, you may need to configure the firewall settings to allow communication through port number 54925 and 137. (See Before using the Brother software.)

Before using Network Scanning

Network licence

This product includes a PC licence for up to 5 Users.
This licence supports the installation of the MFL-Pro Software Suite including Presto! PageManager on up to 5 PCs on the network.
Page Top
Home PrintPrevious Next