Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a Wireless Network When the SSID Is Not Broadcast
Configure Your Machine for a Wireless Network When the SSID Is Not Broadcast
Before configuring your machine, we recommend writing down your wireless network settings. You will need this information before you continue with the configuration.
- Check and write down the current wireless network settings.
Network Name (SSID) Authentication Method Encryption Mode Network Key Open System NONE - WEP *1 Shared Key WEP *1 WPA/WPA2-PSK AES TKIP WPA3-SAE AES *1You cannot select the WEP option from the control panel. To select the WEP option for the encryption mode, use Web Based Management .For example:
Network Name (SSID) HELLO Authentication Method Encryption Mode Network Key WPA3-SAE AES 12345678 - Press
. 
If your machine displays the [All Settings] menu on the Home screen, skip the [Settings] menu. - When [Switch Network interface to wireless?] appears, press [Yes].This will start the wireless setup wizard. To cancel, press [No].
- The machine will search for your network and display a list of available SSIDs. Swipe up or down or press
or 
to display [Add SSID]. Press [Add SSID], and then press [OK]. - Enter the SSID name, and then press [OK].
- Select the Authentication Method.
- Follow the instructions on the LCD to configure the settings.
- The machine attempts to connect to the wireless device you have selected.
If your wireless device is connected successfully, the machine's LCD displays [Connected]. Press [OK], and then press 
.
. You have completed the wireless network setup. To install the drivers or the application necessary for operating your machine, go to your model's Downloads page at support.brother.com/downloads.
Did you find the information you needed?