Search

Site Map

Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a Wireless Network When the SSID is Not Broadcast

Configure Your Machine for a Wireless Network When the SSID is Not Broadcast

Before configuring your machine, we recommend writing down your wireless network settings. You will need this information before you continue with the configuration.

  1. Check and write down the current wireless network settings.
    Network Name (SSID)
      
    Authentication Method Encryption Mode Network Key (Password)
    Open System NONE -
    WEP *1
    Shared Key WEP *1
    WPA/WPA2-PSK/WPA3-SAE TKIP (for WPA/WPA2-PSK)
    AES
    WPA3-SAE AES
    *1
    You cannot select the WEP option from the control panel. To select the WEP option for the encryption mode, use Web Based Management.

    For example:

    Network Name (SSID)
    HELLO
    Authentication Method Encryption Mode Network Key (Password)
    WPA3-SAE AES 12345678
  2. Press image [Settings]>[Network]>[WLAN(Wi-Fi)]>[Find Wi-Fi Network].
  3. When [Enable WLAN?] appears, press [Yes].
    The wireless setup wizard starts. To cancel, press [No].
  4. The machine searches for your network and displays a list of available SSIDs. Press image or image to display the [Add SSID] option, and then press it.
  5. Press [OK].
  6. Enter the SSID name, and then press [OK].
  7. Press image or image to select the Authentication Method, and then press it.
  8. Follow the instructions on the LCD to configure the settings.
  9. The machine attempts to connect to the wireless device you have selected.
If your wireless device is connected successfully, the LCD displays [Connected].

You have completed the wireless network setup. To install the drivers and software necessary to use your machine, go to your model's Downloads page at support.brother.com/downloads.

Related Information
Did you find the information you needed?

find moreaccept