Search

Home > Paper Handling > Load Paper > Load Paper in Paper Tray #1 / Paper Tray #2 > Load Letter, A4, or Executive Size Paper in Paper Tray #1 / Paper Tray #2

Load Letter, A4, or Executive Size Paper in Paper Tray #1 / Paper Tray #2

  • If the [Check Paper] setting is set to [On] and you pull the paper tray out of the machine, a message appears on the LCD, allowing you to change the paper size and paper type.
  • When you load a different paper size in the tray, you must change the Paper Size setting in the machine or the paper size setting on your computer.

    Doing this enables the machine to automatically feed paper from the appropriate tray if Auto Tray Select has been set in the printer driver (Windows) or on the machine. (MFC-J6555DW/MFC-J6740DW/MFC-J6940DW/MFC-J6955DW)

  • You can use only plain paper in Tray #2. (MFC-J6740DW/MFC-J6940DW/MFC-J6955DW)

These instructions describe how to load paper in Tray #1.

  • (MFC-J6740DW/MFC-J6940DW/MFC-J6955DW) The steps for Tray #2 are very similar.
  1. If the paper support flap (1) is open, close it, and then close the paper support (2).
    image
  2. Pull the paper tray completely out of the machine as shown by the arrow.
    image
    image
    (MFC-J6740DW/MFC-J6940DW/MFC-J6955DW)

    When you load paper in Tray #2, remove the tray top cover (1).

    image
  3. Gently press and slide the paper width guides (1) and then the paper length guide (2) to fit the paper size.
    Make sure the triangular mark (3) on the paper width guide (1) and paper length guide (2) line up with the marks for the paper you are using.
    image
    image

    If you load Executive size paper in Tray #1, lift the stopper (4).

    image
  4. Fan the stack of paper well to avoid paper jams and misfeeds.
    image
    image
    Always make sure the paper is not curled or wrinkled.
  5. Gently load paper in the paper tray with the printing surface face down.

    Landscape orientation

    Landscape orientation
    IMPORTANT
    Be careful not to push the paper in too far; it may lift at the back of the tray and cause paper feed problems.
    image
    To add paper before the tray is empty, remove the paper from the tray and combine it with the paper you are adding. Always fan the stack of paper well to prevent the machine from feeding multiple pages.
  6. Make sure the paper length guide (1) touches the edges of the paper.
    image
  7. Gently adjust the paper width guides (1) to fit the paper.
    Make sure the paper guides touch the edges of the paper.
    image
  8. Make sure the paper is flat in the tray and below the maximum paper mark (1).
    Overfilling the paper tray may cause paper jams.
    image
    image
    (MFC-J6740DW/MFC-J6940DW/MFC-J6955DW)

    When you load paper in Tray #2, replace the tray top cover.

    image
  9. Slowly push the paper tray completely into the machine.
    image
    IMPORTANT

    DO NOT push the paper tray into the machine forcefully or quickly. Doing this may cause paper jams or paper feed problems.

  10. Pull out the paper support until it locks into place.
    image
  11. Change the paper size setting in the machine's menu, if needed.
Did you find the information you needed?