For Windows®2000/XP and Windows Vista™ users

For Windows^® 2000/XP and Windows Vista™ users

By default, Windows^® 2000/XP and Windows Vista™ systems install the necessary print software to enable you to print. This section describes the most commonly used configuration, Standard TCP/IP Port printing.

If you have already installed the printer driver, jump to Printer driver already installed.

Configuring the standard TCP/IP port

Printer driver not yet installed

Start the CD-ROM installation menu program according to the Quick Setup Guide.

Select the model name and your language (if necessary), and then click Install Other Drivers or Utilities.

Click Printer Driver (Only, for network).

Click Next in response to the Welcome message. Follow the on-screen instructions.

Select Standard Installation and click Next.

Select Brother Peer-to-Peer Network Printer, and then click Next.

Follow the on-screen instruction, and then click OK.

Note

Contact your administrator if you are not sure about the location and name of the printer in the network.

Continue through the Wizard clicking Finish when complete.

Page Top

Printer driver already installed

If you have already installed the printer driver and wish to configure it for network printing, follow these steps:

1	For Windows Vista™: Click the Start button, Control Panel, Hardware and Sound, and then Printers. For Windows^® XP: Click the Start button and select Printers and Faxes windows. For Windows^® 2000. Click the Start button and select Settings and then Printers.
2	Right click on the printer driver you wish to configure, and then select Properties.
3	Click the Ports tab and click Add Port.
4	Select the port that you wish to use. Typically this would be Standard TCP/IP Port. Then click the New Port... button.
5	The Standard TCP/IP Port Wizard will start.
6	Enter the IP address of your network printer. Click Next.
7	Click Finish.
8	Close Printer Ports and Properties dialog box.

Page Top