Search

Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup (WPS)

Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup (WPS)

If your wireless access point/router supports WPS (PBC: Push Button Configuration), you can use WPS from your machine's control panel menu to configure your wireless network settings.

DCP-L3520CDW

  1. Press Menu.
  2. Press image or image to select the [Network] option, and then press OK.
  3. Press image or image to select the [WLAN(Wi-Fi)] option, and then press OK.
  4. Press image or image to select the [WPS/PushButton] option, and then press OK.
  5. When [WLAN Enable?] appears, select On.
    This will start the wireless setup wizard.
  6. When the LCD displays [Press Key on rtr], press the WPS button on your wireless access point/router. Then follow the LCD instructions on your machine. Your machine will automatically detect your wireless access point/router and try to connect to your wireless network.
If your wireless device is connected successfully, the machine's LCD displays [Connected].

You have completed the wireless network setup. To install the drivers and software necessary to use your machine, go to your model's Downloads page at support.brother.com/downloads.

DCP-L3560CDW/MFC-L3720CDW/MFC-L3755CDW/MFC-L3760CDW/MFC-L3780CDW/MFC-L8340CDW/MFC-L8390CDW

  1. Press image[Settings]>[All Settings]>[Network]>[WLAN(Wi-Fi)]>[WPS/Push Button].
  2. When [Switch Network interface to wireless?] appears, press [Yes].
    This will start the wireless setup wizard. To cancel, press [No].
  3. When the touchscreen displays [Start WPS on your wireless access point/router, then press [OK].], press the WPS button on your wireless access point/router. Then press [OK] on your machine. Your machine will automatically detect your wireless access point/router and try to connect to your wireless network.
If your wireless device is connected successfully, the machine's LCD displays [Connected]. Press [OK], and then press image.

You have completed the wireless network setup. To install the drivers and software necessary to use your machine, go to your model's Downloads page at support.brother.com/downloads.

Did you find the information you needed?