Home PrintPrevious Next

Scan to Image

When you choose Scan to Image, your document will be scanned and sent directly to the Macintosh® you designated on your network. ControlCenter2 will activate the default graphics application on the designated Macintosh®. You can change the Scan configuration. (See Image (example: Apple® Preview).)
1
Load your document.
2
Press Graphic (Scan).
3
Press Bsymbol.utri or Bsymbol.dtri to choose Scan to PC.
Press OK.
4
Press Bsymbol.utri or Bsymbol.dtri to choose Image.
Press OK.
If your machine does not support Duplex Scan, go to step 6.
If your machine supports Duplex Scan, go to step 5.
5
Press Bsymbol.utri or Bsymbol.dtri to choose 1sided, 2sided (L)edge or 2sided (S)edge.
Press OK.
6
Press Bsymbol.utri or Bsymbol.dtri to choose the destination Macintosh® you want to send to.
Press OK.
If the LCD prompts you to enter a PIN number, enter the 4-digit PIN number for the destination Macintosh® on the control panel.
Press OK.
7
Press Start.
The machine starts the scanning process.
Note Note
•
If you want the scanned data in colour, choose colour in the scan type on the Device Button tab of the ControlCenter2 configuration. If you want the scanned data in black and white, choose black and white in the scan type on the Device Button tab of the ControlCenter2 configuration. (See Image (example: Apple® Preview).)
•
If you want to change the default file size, choose your preferred rate by moving the slide bar on the Device Button tab of the ControlCenter2 configuration.
Page Top
Home PrintPrevious Next