You can set your own default settings for Quality, File Type, Glass ScanSize and File Name.
Setting the new default
1 | Press the ( Scan) key. |
2 | Press or to choose Scan to FTP. Press OK. |
3 | Press or to choose Manual. Press OK. Note | If there is no FTP Profile configured, skip 3 and go to 4. |
|
4 | Enter the FTP host address (for example ftp.example.com up to 60 characters) or the IP address (for example 192.23.56.189). Press OK. |
5 | Enter the destination folder (for example /brother/abc/, up to 60 characters). Press OK. |
6 | Enter Username. Press OK. |
7 | Enter Password. Press OK. |
8 | Press and choose your new setting. Repeat this step for each setting you want to change. |
9 | After changing the last setting, press or to choose Set New Default. Press OK. |
10 | Press 1 to choose Yes. |
11 | Press Stop/Exit. |
Factory reset
You can reset Quality, File Type, Glass ScanSize and File Name to the factory settings.
1 | Press the ( Scan) key. |
2 | Press or to choose Scan to FTP. Press OK. |
3 | Press or to choose Manual. Press OK. Note | If there is no FTP Profile configured, skip 3 and go to 4. |
|
4 | Enter the FTP host address (for example ftp.example.com up to 60 characters) or the IP address (for example 192.23.56.189). Press OK. |
5 | Enter the destination folder (for example /brother/abc/, up to 60 characters). Press OK. |
6 | Enter Username. Press OK. |
7 | Enter Password. Press OK. |
8 | Press or to choose Factory Reset. Press OK. |
9 | Press 1 to choose Yes. |
10 | Press Stop/Exit. |