Home > Network Security > Use IEEE 802.1x Authentication for Your Network > Configure IEEE 802.1x Authentication for Your Network Using Web Based Management (Web Browser)
Configure IEEE 802.1x Authentication for Your Network Using Web Based Management (Web Browser)
- If you configure your machine using EAP-TLS authentication, you must install the client certificate issued by a CA before you start configuration. Contact your network administrator about the client certificate. If you have installed more than one certificate, we recommend writing down the certificate name you want to use.
- Before you verify the server certificate, you must import the CA certificate issued by the CA that signed the server certificate. Contact your network administrator or your Internet Service Provider (ISP) to confirm whether a CA certificate import is necessary.
![image](../images/topic1_icon5.png)
You can also configure IEEE 802.1x authentication using the Wireless Setup Wizard from the control panel (Wireless network).
- Start your web browser.
- Type "https://machine's IP address" in your browser's address bar (where "machine's IP address" is your machine's IP address).
For example:
https://192.168.1.2
Your machine's IP address can be found in the Network Configuration Report.
- If required, type the password in the Login field, and then click Login.The default password to manage this machine’s settings is located on the back or base of the machine and marked "Pwd". Change the default password by following the on-screen instructions when you first log in.
- In the left navigation bar, click Network.If the left navigation bar is not visible, start navigating from
.
- Do one of the following:
- For the wired network
Click
. - For the wireless network
Click
.
- Configure the IEEE 802.1x authentication settings.
- To enable IEEE 802.1x authentication for wired networks, select Enabled for Wired 802.1x status on the Wired 802.1x Authentication page.
- If you are using EAP-TLS authentication, you must select the client certificate installed (shown with certificate name) for verification from the Client Certificate drop-down list.
- If you select EAP-FAST, PEAP, EAP-TTLS, or EAP-TLS authentication, select the verification method from the Server Certificate Verification drop-down list. Verify the server certificate using the CA certificate, imported to the machine in advance, issued by the CA that signed the server certificate.
Select one of the following verification methods from the Server Certificate Verification drop-down list:OptionDescriptionNo VerificationThe server certificate can always be trusted. The verification is not performed.CA Cert.The verification method to check the CA reliability of the server certificate, using the CA certificate issued by the CA that signed the server certificate.CA Cert. + ServerIDThe verification method to check the common name *1 value of the server certificate, in addition to the CA reliability of the server certificate.
- When finished with configuration, click Submit.For wired networks: After configuring, connect your machine to the IEEE 802.1x supported network. After a few minutes, print the Network Configuration Report to check the <Wired IEEE 802.1x> status.OptionDescriptionSuccessThe wired IEEE 802.1x function is enabled and the authentication was successful.FailedThe wired IEEE 802.1x function is enabled; however, the authentication failed.OffThe wired IEEE 802.1x function is not available.
*1
The common name verification compares the common name of the server certificate to the character string configured for the Server ID. Before you use this method, contact your system administrator about the server certificate's common name and then configure Server ID.
Did you find the information you needed?