Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a Wireless Network Using the One-Push Method of Wi-Fi Protected Setup™ (WPS)
Configure Your Machine for a Wireless Network Using the One-Push Method of Wi-Fi Protected Setup™ (WPS)
If your wireless access point/router supports Wi-Fi Protected Setup™ (WPS), you can use WPS from your machine's control panel to configure your wireless network settings.
ADS-1350W
- Press and hold
for two seconds. - When the Wi-Fi LED starts flashing, press the WPS button on your wireless access point/router. Your machine automatically tries to connect to your wireless network.
If your wireless device is connected successfully, the Wi-Fi LED stops flashing and remains lit.
You have completed the wireless network setup. To install drivers and software necessary for operating your machine, go to your model's Downloads page at support.brother.com/downloads.
ADS-1800W
- Press
. - When [Enable WLAN? Do you want to continue?] appears, press [Yes].The wireless setup wizard starts. To cancel, press [No].
- When the touchscreen instructs you to start WPS, press the WPS button on your wireless access point/router. Press [OK], and then your machine automatically tries to connect to your wireless network.
If your wireless device is connected successfully, the LCD displays [Connected].
You have completed the wireless network setup. To install drivers and software necessary for operating your machine, go to your model's Downloads page at support.brother.com/downloads.
Did you find the information you needed?