Search

Site Map

Home > Scan > Scan Using Brother iPrint&Scan (Windows/Mac) > Configure Scan to Workflow Settings Using Brother iPrint&Scan

Configure Scan to Workflow Settings Using Brother iPrint&Scan

The following conditions must be satisfied to use Scan to Workflow:

  • Windows

    • The scanner driver is installed.

      Download and install the driver at support.brother.com/downloads.

    • Default settings have been configured for scanning from the machine.

      Configure the settings by following the on-screen directions in the Machine Scan Settings screen.

  • Mac

    • iPrint&Scan Push Scan Tool is installed.

      Download and install the iPrint&Scan Push Scan Tool at support.brother.com/downloads.

    • Default settings have been configured for scanning from the machine.

      In the Brother iPrint&Scan home screen, click Machine Scan Settings>Select folder..., and save where applicable. Complete the process by following the on-screen instructions.

Create a Workflow

  1. In the Brother iPrint&Scan home screen, click Create Workflow.
  2. Create a workflow by following the on-screen instructions.
image
If you want to scan from your machine, check the Set this workflow. It can be started from the control panel of your machine. checkbox before clicking the Save button.

Configure Workflows

  1. In the Brother iPrint&Scan home screen, click Machine Scan Settings>Workflow.
  2. Select the workflow you want to display when the Workflow button is pressed on the machine, and click OK.

Edit or delete the Workflow

  1. In the Brother iPrint&Scan home screen, click imageApplication Setting>Workflow Management.
  2. Select the workflow you want to edit or delete, and click either Edit or Delete.
Related Information
Did you find the information you needed?

find moreaccept