This section describes how to configure the wireless network settings and establish a wireless network connection, if you did not configure the wireless network settings during the installation.
Note
| | If the P-touch is powered by alkaline or Ni-MH batteries, you cannot establish a wireless network connection. Use the rechargeable Li-ion battery or the AC adapter. |
Using WPS (Wi-Fi Protected Setup™)
If your WLAN access point/router supports WPS (Wi-Fi Protected Setup™), settings and connections can be configured easily with the press of a button.
| 1 | First, confirm that your WLAN access point/router has the WPS symbol. |
| 2 | Press and hold the Wireless Mode button on the P-touch for more than 5 seconds. After the Wi-Fi lamp starts flashing in 0.5 second intervals, release the button. |
| 3 | Press the WPS button on your WLAN access point/router. |
| 4 | When the connection is established, the Wi-Fi lamp is lit. |
Note
| | The printer will try to connect using WPS for 2 minutes. If the Wireless Mode button is pressed and held for 5 seconds during that time, the printer will continue trying to connect for an additional 2 minutes starting from that point. |
