Home PrintPrevious Next

When Printing via a Wireless Network Connection

Note Note
If the P-touch is powered by alkaline or Ni-MH batteries, you cannot establish a wireless network connection. Use the rechargeable Li-ion battery or the AC adapter.
When you want to print via a wireless network connection, it is recommended that you configure the wireless network settings while installing the application.
You can change the wireless network settings later using the Printer Setting Tool. (For Windows only)
For more information, see Printer Setting Tool (for Windows).
The following installation methods are available.
Visit our website described below and download the necessary software. The installation instructions are available on the download page.
•
For Windows: install.brother
•
For Macintosh: The [Downloads] page on the Brother support website (support.brother.com)
Wireless configuration temporarily using a USB cable
It is recommended that you use a computer wirelessly connected to your network for this method.
You can remotely configure the P-touch from the computer on the network using a USB cable.
One-push configuration using WPS (Wi-Fi Protected Setup™)
You can use WPS to configure your wireless network settings quickly, if your WLAN access point/router supports WPS.
Page Top
Home PrintPrevious Next