On / Off

Turn the WLAN function on or off.

Direct / Infrastructure / Direct/Infra

Select the network mode when you set the WLAN function to on.

Button Push / PIN Code

Select the WPS network settings method.

Display the IP Address.

On / Off

Turn the Bluetooth function on or off.

Mode

Classic & LE / Classic / Low Energy

Select the Bluetooth mode.

On / Off

Switch to Automatic Reconnection mode (only for Apple devices: iPad, iPhone, or iPod touch).

Delete the information for auto re-paired devices registered in the printer.

On / Off

Select whether to perform confirmation during Bluetooth pairing.

Standard Mode / Secure Mode

Select the security mode for Bluetooth connection.

Display the Bluetooth address.

Print the Bluetooth address and corresponding barcode.

-

Select the paper size and paper type or check the current paper size setting.

The list contains:

• Default media (Nine types. Default: 3.0" x 1.7" (76 mm x 44 mm))

• User-defined media (Ten types)
• Auto-detected media
• Media settings obtained using the Auto Detect function.

-

Automatically adjust the sensor sensitivity and detect the length of the set paper. Specify Settings in advance.

-

Configure the settings before performing Auto Detect.

Width

Select the paper width to be auto-detected.

Sensor Type

Select the sensor type: Die-cut, Mark, or Continuous.

Sensor Calibr

Enable or disable sensor calibration during auto-detection.

Media Timeout

Set the auto-detected paper to Continuous if Auto Detect does not find any gap or black mark according to the Media Timeout length.

Energy Rank

Select the energy rank to adjust the print density.

Exit Position

(RJ-3235B/RJ-3255WB)

Tear / Peeler

Select the media exit method.

Dansk / Deutsch / English / Español / Français / Italiano / Nederlands / Norsk / Português / Suomi / Svenska / 日本語

Select the language.

LCD Contrast

+2 / +1 / 0 / -1 / -2

Set the contrast of the LCD. The higher the number, the stronger the contrast.

On / Off

Enable or disable the beeper.

100% / 80%

Charging settings

Check the firmware version, font version, and available memory.

Tear Bar

Upward / Downward

Adjust the tear position.

This setting appears when the Linerless is set to Off in the Advanced tab of the BRConfiguration Tool.

Shows the Select Media screen for ten seconds after you close the Roll Compartment Cover.

Feeds the label automatically when you close the Roll Compartment Cover.

Performs Auto Detect automatically when you close the Roll Compartment Cover. The printer displays the detected paper size, and then displays the Ready screen.

No action and no change on the LCD.

Clock

On / Off

Show or hide the clock icon on the LCD.

AutoSync Time

On / Off

This setting appears when Clock is set to On.

Time Zone

Set the time zone. This setting appears when Clock is set to On.

Date&Time

Display the date and time.

This setting appears when Clock is set to On.

Update

(RJ-3235B/RJ-3255WB/RJ-4255WB)

Select the checkboxes for any options you want to prevent changes from the printer's LCD.

After selecting the checkboxes, press the Menu / (Select) button to select Finish, and then press the (Feed) / OK button to complete the settings.

If the Menu Locks are set, the selected options would not be displayed on the LCD.

WLAN

(RJ-3255WB/RJ-4255WB)

Wired LAN

(RJ-3235B/RJ-3255WB)

On / Off

Select if a passcode is required to enter the Administration mode.

When set to on, specify the four-digit password.

Start / Back

Print information on data received to date.

On / Off

Select whether to use Web Based Management.