Home > Appendix > Optional Accessories > Charging Cradle (Optional: PA-CR-002A) > Mount the Charging Cradle on the Wall (Optional: PA-CR-002A)
Mount the Charging Cradle on the Wall (Optional: PA-CR-002A)
- Affix the Charging Cradle to the wall using four screws, as shown in the illustration.
- Height: 30 mm
- Width: 38.1 mm
- Make sure you install the Charging Cradle in the correct direction so that the printer will not fall.
- Use screws with the following dimensions: Length: 25 mm or more, Diameter: 9.8 mm or less.
Did you find the information you needed?