Search

Settings Tables

The Settings tables describe the menu selections and options.
image
Some settings may differ depending on the firmware (printer software) version.

[WLAN]

Level 1
Level 2
Descriptions
On/Off
On / Off
Turn the WLAN function on or off.
Mode
Direct / Infrastructure / Direct/Infra
Select the network mode when you set the WLAN function to on.
WPS
Button Push / PIN Code
Select the WPS network settings method.
WLANAssistant
Start / Back
Use the WLAN connection assistant function to configure your wireless network settings.
IP Address
Display the IP Address.

[Bluetooth]

Level 1
Level 2
Descriptions
On/Off
On / Off
Turn the Bluetooth function on or off.
Mode
Classic & LE / Classic / Low Energy
Select the Bluetooth mode.
AutoReconnect
On / Off
Switch to Automatic Reconnection mode (only for Apple devices: iPad, iPhone, or iPod touch).
Clear History
Delete the information for auto re-paired devices registered in the printer.
BT Address
Display the Bluetooth address.
Print Barcode
Print the Bluetooth address and corresponding barcode.

[Wired LAN]

Level 1
Level 2
Descriptions
Cradle LAN
On / Off
Select the wireless (infrastructure) or wired connection when the printer is placed on the Charging Cradle.
IP Address
Display the IP Address.

[Media]

Level 1
Level 2
Descriptions
Select Media

-

Select the paper size and paper type or check the current paper size setting.

The list contains:

  • Default media (Nine types. Default: 76 mm x 44 mm)

  • User-defined media (Ten types)
  • Auto-detected media
  • Media settings obtained using the Auto Detect function.
Auto Detect

-

Automatically adjust the sensor sensitivity and detect the length of the set paper. Specify Settings in advance.
Settings *1

-

Configure the settings before performing Auto Detect.
Width
Select the paper width to be auto-detected.
Sensor Type
Select the sensor type: Die-cut, Mark, or Continuous.
Sensor Calibr
Enable or disable sensor calibration during auto-detection.
Media Timeout
Set the auto-detected paper to Continuous if Auto Detect does not find any gap or black mark according to the Media Timeout length.
Energy Rank
Select the energy rank to adjust the print density.
*1
Requires from the firmware version 1.09 or later.

[Settings]

Level 1
Level 2
Descriptions
Exit Position
Tear / Peeler
Select the media exit method.
Language
Dansk / Deutsch / English / Español / Français / Italiano / Nederlands / Norsk / Português / Suomi / Svenska / 日本語 / 繁體中文
Select the language.
LCD Contrast
+2 / +1 / 0 / -1 / -2
Set the contrast of the LCD. The higher the number, the stronger the contrast.
Beeper
On / Off
Enable or disable the beeper.
Configuration
Check the firmware version, font version, and available memory.
Tear Bar
Upward / Downward
Adjust the tear position.

This setting appears when the Linerless is set to Off in the Advanced tab of the Printer Setting Tool.

Cover Setting *1
Select Media

Shows the Select Media screen for ten seconds after you close the Roll Compartment Cover.

Feed
Feeds the label automatically when you close the Roll Compartment Cover.
Auto Detect

Performs Auto Detect automatically when you close the Roll Compartment Cover. The printer displays the detected paper size, and then displays the Ready screen.

None
No action and no change on the LCD.
Clock
On / Off
Show or hide the clock icon on the LCD.
AutoSync Time
On / Off
This setting appears when Clock is set to On.
Time Zone
Set the time zone. This setting appears when Clock is set to On.
Date&Time
Display the date and time.

This setting appears when Clock is set to On.

*1
Requires from the firmware version 1.09 or later.
Did you find the information you needed?