Home > Appendix > Auto Media Configuration > Auto Media Configuration Overview
Auto Media Configuration Overview
Auto Media Configuration allows the printer to automatically detect characteristics of the installed paper, and then select the correct paper size settings.
Model | Automatically Detects: |
|---|---|
TD-2310D | Length *1 |
TD-2320D/TD-2350D/TD-2350DSA |
|
TD-2320DF/TD-2350DF |
|
Auto Media Configuration Workflow
When Auto Media Configuration begins, the printer automatically feeds the media so it can detect its characteristics. By default, the printer uses the continuous feed setting unless:
- The transmissive/gap sensor detects a die-cut label.
- The reflective/black mark sensor detects marked media. *2
- If there is not enough media and it runs out during Auto Media Configuration, the printer will not detect the media type successfully. The LCD will display an error message. Follow the on-screen instructions and try again.
- If the media is not aligned correctly, calibration will not be successful.
- Depending on the media's shape and material, media detection may not be possible.
- TD-2310D:
Width defaults to the width of the last media you used.
- TD-2320D/TD-2350D/TD-2320DF/TD-2350DF/TD-2350DSA:
Width is calculated automatically by subtracting 0.07" (2.0 mm) from the left and right of the detected width.
*1
Available when you select the Paper Size Setup option on the Printer Setting Tool.
*2
Depending on the results, you may have to feed the media again.
Did you find the information you needed?