Home > Set Up Your Printer > Load Media Roll > Load a Media Roll
Load a Media Roll
- Press and hold
to turn the printer off.
- Pull up the release levers on both sides of the printer to unlock the Roll Compartment Cover.
- Hold the front of the printer, and firmly lift the Roll Compartment Cover to open it.
- CAUTION
- Do not touch the Tear Bar with your hands. Doing so may result in injury.
- Slide both Roll Guides outwards.
- Insert the roll so that the label's printing surface is facing up, as shown in the illustration.
- Rotate the Adjuster Dial to lock the Roll Guides in the appropriate position.
- Feed the end of the backing paper under the Media Guide Tips (1).Make sure the label extends slightly out of the Label Exit Slot.
- NOTE
- To avoid labels being fed diagonally when using media with a width of 0.9" (22.9 mm) or less, make sure the media exiting from the Label Exit Slot is coming directly out and is not at an angle.
Top View
- Close the Roll Compartment Cover until it locks into place.
- CAUTION
- Be careful when closing the Roll Compartment Cover. There is a risk of injury if your finger gets pinched between the upper and lower parts of the cover.
- IMPORTANT
-
- Do not leave any printed labels in the printer. Doing so will cause label jams.
- When the printer is not in use, remove any rolls from it and close the Roll Compartment Cover.
Did you find the information you needed?