CM300
 |
Întrebări frecvente şi depanare |
Sortare după
16 Rezultate
1. 26/12/2018
If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
2. 10/07/2017
Mat and Material Combinations
3. 10/07/2017
Mat and Cutting Blade Combinations
4. 10/07/2017
The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
5. 10/07/2017
The mat is fed in at an angle and is not fed during cutting / drawing.
6. 10/07/2017
The mat or the material catches on a feed roller during cutting/drawing.
7. 10/07/2017
When the mat is inserted, the attached material peels off.
8. 10/07/2017
The material to be cut/drawn or original to be scanned cannot be attached to the mat.
9. 22/10/2015
The 12" × 24" (305 mm × 610 mm) mat cannot be used with scanning function.
10. 19/08/2015
There are deep cuts completely through the mat.
11. 31/07/2015
The mat cannot be fed.
12. 31/07/2015
The mat cannot be recognized.
13. 22/01/2014
The mat cannot be inserted.
14. 28/11/2013
The mat or the material catches on a feed roller when the mat is being inserted.
15. 28/11/2013
The mat cannot be fed out.
16. 28/11/2013
The mat is fed in at an angle.