CM600
FAQ et Diagnostic |
Trier par
9 Résultats
1. 10.07.2017
Not all of the material to be cut is cut. Some areas remain uncut.
2. 10.07.2017
The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
3. 10.07.2017
The mat is fed in at an angle and is not fed during cutting / drawing.
4. 10.07.2017
The mat or the material catches on a feed roller during cutting/drawing.
5. 09.06.2017
I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good.
6. 16.01.2017
What should I do if the entire pattern is not cut?
7. 16.01.2017
What should I do if part of the material is not cut?
8. 08.08.2016
What should I do if the scanned and cut positions are misaligned?
9. 19.08.2015
There are deep cuts completely through the mat.