SDX125e Titanium
Preguntas frecuentes y solución de problemas |
SDX125e Titanium
Fecha: 10/03/2018 ID: faqh00000691_002
The mat is fed in at an angle.
Possible Causes (or Results)
Case1 : | The mat was inserted into the feed slot at an angle. |
Case2 : | The corners of the mat are deformed (bent). |
Case3 : | The rear tray is not pulled out. |
Case4 : | The feed roller is not positioned correctly. |
Case5 : | The shaft is released. |
Solutions
----- Case1 -----
Press the (Feed) button to feed out the mat.
Re-insert the mat straight in.
----- Case2 -----
Replace the mat with a new one.
----- Case3 -----
Pull out the rear tray.
----- Case4 -----
Adjust the position of the feed roller.
For details, refer to Adjusting the Position of the Feed Roller
----- Case5 -----
Lock the shaft.
SDX125, SDX125e, SDX125e Titanium, SDX125i, SDX125TS, SDX135PRO, SDX225, SDX225F, SDX230D, SDX230Di, SDX230DX, SDX325, SDX330D, SDX85, SDX85C, SDX85M, SDX85S
Si necesita asistencia, contáctese con el servicio al cliente de Brother:
Comentarios sobre el contenido
Para ayudarnos a mejorar el soporte, bríndenos sus comentarios a continuación.
Paso 1: ¿Cómo lo ayudó la información en esta página?
Paso 2: ¿Quiere agregar otros comentarios?
Observe que este formulario solo se utiliza para comentarios.