TD-4650TNWBR
Vanliga frågor & felsökning |
TD-4650TNWBR
Datum: 2020-06-24 ID: faqp00100507_000
RFID calibration does not finish or fails. I cannot write RFID tags.
To solve this issue, try one of the following suggestions:
- Make sure smart labels with RFID tags are located in the correct position.
-
The RFID tag could be defective. Try another tag.
Always test RFID media on your printer before purchasing large quantities of media.
- Set the label size correctly. Then calibrate the RFID tag.
- Set the sensor sensitivity correctly (Sensor > Gap/Bline Ref Rate).
- Check the data length size of the RFID commands.
Om du behöver mer hjälp kontaktar du Brothers kundtjänst:
Feedback om innehållet
Hjälp oss att göra vår support bättre genom att lämna din feedback nedan.
Steg 1: Hur hjälper informationen på den här sidan dig?
Steg 2: Vill du lägga till ytterligare kommentarer?
Observera att detta formulär endast används för feedback.