Innov-is XJ2
 |
Vanliga frågor & felsökning |
Innov-is XJ2
Datum: 2019-07-29 ID: faqh00101088_001
Fabric does not feed through the machine.
-
Feed dogs are set in the down position.
Press
, and then turn the handwheel to raise the feed dogs.
-
Stitches are too close together.
Lengthen the stitch length setting.
Refer to How do I adjust a stitch width or length?
-
Wrong presser foot.
Use the correct presser foot.
-
Needle is turned, bent or the point is dull.
Replace the needle.
Refer to How do I change the needle ?
-
Thread is entangled.
Cut the entangled thread and remove it from the race.
-
Zigzag foot J is slanted on a thick seam at the beginning of stitching.
Use the presser foot locking pin (black button on the left side) on zigzag foot J to keep the presser foot level while sewing.
Refer to Tips for sewing thick fabrics.
Feedback om innehållet
Hjälp oss att göra vår support bättre genom att lämna din feedback nedan.
Steg 1: Hur hjälper informationen på den här sidan dig?
Steg 2: Vill du lägga till ytterligare kommentarer?
Observera att detta formulär endast används för feedback.