Innov-is 27SE
Vanliga frågor & felsökning |
Innov-is 27SE
Datum: 2009-04-07 ID: faqh00000006_000
Place a spool of thread on a spool pin.
<Horizontal spool pin>
If a spool of thread turns too much and thread tension becomes improper, place a felt under the spool of thread.
- Firmly hold the thread with a spool cap so that the thread does not turn too much.
Spool cap Make sure you use the correct size spool cap for the thread. If the spool cap is smaller the thread, tension may be incorrect.
- If you dont have a spool cap larger than the size of the thread, there is a slit in the thread spool.
Slit(Notch) Install the spoll so that the slit faces the base of the spool pin.
- It is important that the thread is pulled out from the spool smoothly. Make sure there is space around the spool cap and the tip of the spool pin for thread to pass through.
If a spool of thread turns too much and thread tension becomes improper, place a felt under the spool of thread.
Felt Spool pin |
Om du behöver mer hjälp kontaktar du Brothers kundtjänst:
Feedback om innehållet
Hjälp oss att göra vår support bättre genom att lämna din feedback nedan.
Steg 1: Hur hjälper informationen på den här sidan dig?
Steg 2: Vill du lägga till ytterligare kommentarer?
Observera att detta formulär endast används för feedback.